Worlds worst welder

welding — commander flatus @ 2:29 pm April 24, 2013

Right here. No arguing.

Welding thin sheet metal

smoking,welding — commander flatus @ 8:51 pm April 18, 2013

Just can’t get the hang of it. Temporary setback, need to redesign…


smoking,welding — commander flatus @ 3:23 pm March 24, 2013

So the idea is to build an automated, network-connected smoker out of a recycled stainless steel half barrel keg. So far, I’ve just setup this jig to the keg to plasma cut the top off. This will be the lid. Later, I’ll weld a sheet metal “lip” around the circumference of the base to hold the lid in place and prevent smoke and heat leakage.

I’m trying to cut just below the seam where the keg was originally welded.

So off comes the top:

Cutting holes for the air inlets/outlets and temperature probe:

Here is why we wear safety goggles:

And here is stick welding stainless (mfugly):


Location:Richmond Pl,New Orleans,United States

This work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 Unported License.
(c) 2020 polydipsia | powered by WordPress with Barecity